DOMED original Batman Ford emblem overlays 3M™ F-150 Super Duty & other models

Description

This ultra-conformable vinyl is repositionable!
To find the size you need. simply measure the BLUE area of your factory grill and tailgate/rear hatch/trunk emblems. It is important to confirm the size you need, especially if you purchased your vehicle used, as sometimes the previous owner has swapped out the emblems, grills or entire tailgates for one from a different year. See below info for help in sizing:
Steering wheels (most ALL years/models, but measure to confirm) = .875in x 2.25in
-1999-2004 Super Duty GRILL emblems = 2.375in x 6.3in
-2005-2010 Super Duty GRILL emblems = 3.2in x 8.2in
-2011-2016 Super Duty GRILL emblems = 4.56in x 12in
-1999-2004 Super Duty TAILGATE emblems = 2in x 5in
-2005-2016 Super Duty TAILGATE emblems = 3.2in x 8.2in
**NOTE: if your vehicle has the factory back-up camera inside the rear emblem, you will need a 2.375in x 6.3in size overlay. Measure to confirm!**
-2017+ Super Duty GRILL emblems = 4.125in x 10.875in
-2017+ Super Duty TAILGATE emblems = 4.125in x 10.875in
**NOTE: if your Super Duty has the Limited, Platinum or King Ranch package, you will need a 1.75in x 4.625in size tailgate overlay. (The smaller emblem will be on the lower right side of the tailgate) Measure to confirm!**
-2006-2014 F-150 GRILL and TAILGATE emblems = 3.2in x 8.2in
**NOTE: if your vehicle has the factory back-up camera inside the rear emblem, you will need a 2.375in x 6.3in size overlay. Measure to confirm!**
-2015+ F-150 GRILL and TAILGATE (except Platinum) emblems = 3.312in x 8.625in
**NOTE:  Platinum and King Ranch editions will require a 1.75in x 4.625in tailgate emblem overlay. Measure to confirm!**
The sizes in the drop-down menus may fit many other models as well...just measure the BLUE area to find out!
These are flexible, vinyl *OVERLAYS* that are designed to install over your factory Ford emblems- the factory emblems are
NOT
included- sorry!
How hard are these to install? Not hard at ALL! Why? Because this very high-tech, specialty vinyl allows you to position the overlay and then lift it back up if you need to- again and again and again until you apply pressure and make it "permanent"! Install them DRY with no worries!! When you want to remove it- simply heat it up (hair dryer works fine if you do not have a heat gun) and peel it off. AND it's removable up to 4yrs without leaving any residue or adhesive behind!
From the manufacturer:
"Durable, dimensionally stable, vinyl film with positionable, pressure activated adhesive (permanent, changeable or removable) that allows it to be repositioned on the application surface during installation. Special channels allow trapped air to escape, which reduces air bubbles that typically occur as large format graphics are installed."
We don't just throw these decals in an envelope and slap a $.49 stamp on them!! They will be sandwiched between two layers of thick Coroplast®- these babies won't show up damaged!!